Dismantled on 26.7.2024 after 69 flights (last was on 24.4.2019). See Martian IV (3 inch) for a better 3" build or AlfaRC Fi-115 (2.5 inch) for a 2.5" build.
RCX H130CF
| Specifications | |
|---|---|
| Frame | RCX H130CF |
| FC | F3 V1 RacerCube w/ |
| BEC | 5V 2A external |
| ESC | BLHELI_S V1 10A 4in1 ESC (from MyRCMart) |
| Motors | RCX H1407 3200KV |
| Props | HQProp 3x3x3 |
| Receiver | FrSky R-XSR |
| Camera | RunCam Split Mini |
| VTX | Eachine VTX03 |
| Antenna | Realacc UXII Stubby RHCP antenna |
| Battery | Tattu 4S 650 mAh 75C |
| Weight | |
| M2M | 13 cm |
| Flight time | 3-5 minutes |
Videos
- https://www.youtube.com/watch?v=gB-a88O0nOM (RunCam Split Mini HD)
- https://www.youtube.com/watch?v=ODIG3XV5sLc (RunCam Split Mini HD)
- https://www.youtube.com/watch?v=pmU5Tku2-wU (before RunCam Split Mini)
Notes
- Edges of frame pieces should be sanded to avoid wear in wiring
- Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
- Motor KV is too low for 3S batteries, can be flown but feels underpowered
- OSD chip is including severe noise to video when going past 3S, caps and filters don't help, removing BEC from FC and using external BEC solved the issue
Wiring
- Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
- V2 is much less messy to use and it doesn't require a separate battery wiring to FC
- The battery wires are on the bottom of the ESC board so be extra careful not to let plain wires touch the frame
- Use a piece of electric tape just to be on the safe side