Differences

This shows you the differences between two versions of the page.

--- rc:3s-quadcopter [05.12.2011 03:08]
vergo
+++ rc:3s-quadcopter [01.03.2015 20:39] (current)
vergo
@@ Line 1: / Line 1: @@
+~~NOTOC~~
+<note important>This quadcopter was dismantled on 1.3.2015 after 76 flights having served me well as a learning platform for both LoS and FPV flight. The last flight can be viewed [[https://www.youtube.com/watch?v=VpSk6reU2yQ|here]].</note>
 ====== 3S Quadcopter ======
@@ Line 108: / Line 112: @@
 ===== The brain =====
+<note tip>Note: the flight controller part below was written in late 2011, now in 2013 a all-in-one flight controller is a better option. The software has also been updated several times and using a several year old release isn't suggested.</note>
 ==== Assembly ====
@@ Line 147: / Line 153: @@
   - extract the "MultiWii_1_8_patch2" directory to the installed Arduino Sketches directory
   - after starting the Arduino SDK, MultiWii should be visible in the load sketches menu
-  - open the config.h and configure it based on your needs
+  - open the config.h and configure it based on your needs (changes compared to 1.8p2 defaults for FreeIMU v0.3.5_BMP and my setup)
-    * //this step will be written in more details//
+    * #define MINTHROTTLE 1180
+    * %%//#define INTERNAL_I2C_PULLUPS%%
+    * %%//#define FAILSAFE%%
+    * #define FREEIMUv035_BMP
+    * #define ITG3200_LPF_98HZ
+    * #define SERIAL_SUM_PPM ... %%// Futaba%%
+    * %%//#define VBAT%%
   - run Verify to check for errors
   - select the correct Arduino board: Tools -> Board -> Arduino Pro Mini (5V, 16 MHz) w/ ATmega 328

HumdiWiki

User Tools

Site Tools

Differences

Page Tools