This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
rc:diy-h-frame-fpv-quadcopter [12.06.2016 16:17] vergo |
rc:diy-h-frame-fpv-quadcopter [19.06.2016 13:16] (current) vergo |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ~~NOTOC~~ | ~~NOTOC~~ | ||
| + | |||
| + | <note important> | ||
| ====== DIY H-Frame FPV Quadcopter ====== | ====== DIY H-Frame FPV Quadcopter ====== | ||
| - | {{ : | + | {{ : |
| ^ Specifications | ^ Specifications | ||
| - | | Frame | DIY | | + | | Frame | DIY (Plywood frame + square aluminium arms) | |
| | FC | Naze32 (full), rev 5 | | | FC | Naze32 (full), rev 5 | | ||
| | Motor | T-Motor MT2206-23 1200KV x 4 | | | Motor | T-Motor MT2206-23 1200KV x 4 | | ||
| Line 27: | Line 29: | ||
| * Outdated and heavy design | * Outdated and heavy design | ||
| * Bigger 3S or similar 4S battery would likely have been more suitable | * Bigger 3S or similar 4S battery would likely have been more suitable | ||
| + | * Used motors are rated for 2-3S | ||
| * Lack of BEC causes one ESC to heat up far too much | * Lack of BEC causes one ESC to heat up far too much | ||
| * Long frame causes too easily shadows for signals | * Long frame causes too easily shadows for signals | ||
| + | |||
| + | ===== The Plan ===== | ||
| + | |||
| + | {{: | ||