HumdiWiki

User Tools

Site Tools

Trace: • realacc-martian-iv-3-inch-walksnail
rc:realacc-martian-iv-3-inch-walksnail

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
rc:realacc-martian-iv-3-inch-walksnail [29.07.2024 01:38]
vergo 		rc:realacc-martian-iv-3-inch-walksnail [07.09.2025 00:52] (current)
vergo
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
  
-<note important>Not fully tested yet!</note>+<note important>Flyable, but PID tune needs to be improved as something causes noticable oscillations at over 80% throttle</note>
  
 ====== Martian IV (3 inch, Walksnail) ====== ====== Martian IV (3 inch, Walksnail) ======
Line 7: Line 7:
 ^  Specifications  ^^ ^  Specifications  ^^
 | Frame | Realacc Martian IV (3 inch) | | Frame | Realacc Martian IV (3 inch) |
-| FC+ESC | HGLRC F4 Zeus |+| FC+ESC | HGLRC F4 Zeus AIO 15A |
 | Motors | RCX H1304 5000KV | | Motors | RCX H1304 5000KV |
 | Props | Emax Avan 3x2.4x3\\ GemFan 3x1.6x3 | | Props | Emax Avan 3x2.4x3\\ GemFan 3x1.6x3 |
 | Receiver | HappyModel EP1 TCXO (ELRS) | | Receiver | HappyModel EP1 TCXO (ELRS) |
 | Camera | Walksnail Avatar HD Pro Camera | | Camera | Walksnail Avatar HD Pro Camera |
-| VTX | Walksnail Avatar HD Pro  | +| VTX | Walksnail Avatar HD Pro | 
-| Antenna | TrueRC CORE - 45 mm, U.FL, LHCP |+| Antenna | TrueRC Singularity - 72 mm, U.FL, LHCP |
 | Battery | Tattu 3S 450 mAh 75C\\ Turnigy nano-tech 3S 850 mAh 45C | | Battery | Tattu 3S 450 mAh 75C\\ Turnigy nano-tech 3S 850 mAh 45C |
 ^ ^^ ^ ^^
 | Weight | 137 g\\ 180 g (with 3S 450 mAh battery) | | Weight | 137 g\\ 180 g (with 3S 450 mAh battery) |
 | M2M | 14 cm | | M2M | 14 cm |
-| Flight time | ? minutes |+| Flight time | 5+ minutes |
  
 ===== Notes ===== ===== Notes =====
Line 27: Line 27:
   - Walksnail Avatar VTX doesn't have passthrough holes for 20x20 mm stack (or any other for that matter) but long screws from the bottom of the frame have been used instead for mounting leaving decent space below and plenty about the VTX   - Walksnail Avatar VTX doesn't have passthrough holes for 20x20 mm stack (or any other for that matter) but long screws from the bottom of the frame have been used instead for mounting leaving decent space below and plenty about the VTX
   - Walksnail Avatar HD Pro Kit doesn't come with a camera mount and the hole pattern isn't the same as in RunCam cameras   - Walksnail Avatar HD Pro Kit doesn't come with a camera mount and the hole pattern isn't the same as in RunCam cameras
 +  - VTX is rated for 6V-25.2V (2-6S) while FC is 3S and doesn't have a 9V regulator, that's why VTX is directly connected to battery as there's enough headroom for that to not cause problems
   - The FC doesn't have pads for the beeper resulting in the connector needing to be used for it   - The FC doesn't have pads for the beeper resulting in the connector needing to be used for it
 +  - Emax Avan 3x2.4x3 feels to be the better prop compared to GemFan 3x1.6x3 and HQProp T3x3x3 which was also tested but concluded to have a too high pitch, Gemfan Hurricane 3020-3 hasn't been tested
  
 ===== Wiring ===== ===== Wiring =====
rc/realacc-martian-iv-3-inch-walksnail.1722206320.txt.gz · Last modified: 29.07.2024 01:38 by vergo

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki