Differences

This shows you the differences between two versions of the page.

--- rc:zohd-drift-walksnail [12.10.2025 21:22]
vergo created
+++ rc:zohd-drift-walksnail [12.10.2025 22:10] (current)
vergo
@@ Line 1: / Line 1: @@
+~~NOTOC~~
 ====== ZOHD Drift (Walksnail) ======
+{{ :rc:files:zohddrift:zohd_drift_on_table.jpg?direct&400|}}
 ^  Specifications  ^^
 | Motor | RCX H1306 2300KV |
-| Prop | Dalprop 5x3 |
+| Prop | Dalprop 5x3 (2-blade) |
 | ESC | RacerStar 12A V2 (Bluejay 0.21) |
 | Servos | ZOHD kit original |
@@ Line 32: / Line 36: @@
     * GPS didn't find any satellites after everything had been assembled
       * Adding some tin foil under the antenna solved the issue
+    * FC didn't have screw holes at the bottom unlike Matek's product picture show so it had to be mounted with double sided tape instead of screws
   * The CG marks aren't forward enough
   * FC was built with forward facing servo connector on the top board while ESC and BEC are below
+  * RX is fixed on top of FC with double sided tape due to reach of the antenna wire
   * VTX is sideways behind the camera, this is enough for cooling it while the plane is in flight
   * A 3D printable bracket was designed to keep the camera in place without blocking air flow
@@ Line 41: / Line 47: @@
 ===== Wiring =====
+{{:rc:files:zohddrift:zohd_250g_walksnail_matek_f405_wmn.png?direct&450|}}
+\\ \\
+{{:rc:files:zohddrift:zohd_drift_wiring.jpg?direct&600|}}

HumdiWiki