rc:zohd-drift-walksnail
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
rc:zohd-drift-walksnail [12.10.2025 21:51] vergo [Wiring] |
rc:zohd-drift-walksnail [12.10.2025 22:10] (current) vergo |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ~~NOTOC~~ | ||
| + | |||
| ====== ZOHD Drift (Walksnail) ====== | ====== ZOHD Drift (Walksnail) ====== | ||
| + | |||
| + | {{ : | ||
| ^ Specifications | ^ Specifications | ||
| | Motor | RCX H1306 2300KV | | | Motor | RCX H1306 2300KV | | ||
| - | | Prop | Dalprop 5x3 | | + | | Prop | Dalprop 5x3 (2-blade) |
| | ESC | RacerStar 12A V2 (Bluejay 0.21) | | | ESC | RacerStar 12A V2 (Bluejay 0.21) | | ||
| | Servos | ZOHD kit original | | | Servos | ZOHD kit original | | ||
| Line 35: | Line 39: | ||
| * The CG marks aren't forward enough | * The CG marks aren't forward enough | ||
| * FC was built with forward facing servo connector on the top board while ESC and BEC are below | * FC was built with forward facing servo connector on the top board while ESC and BEC are below | ||
| + | * RX is fixed on top of FC with double sided tape due to reach of the antenna wire | ||
| * VTX is sideways behind the camera, this is enough for cooling it while the plane is in flight | * VTX is sideways behind the camera, this is enough for cooling it while the plane is in flight | ||
| * A 3D printable bracket was designed to keep the camera in place without blocking air flow | * A 3D printable bracket was designed to keep the camera in place without blocking air flow | ||
rc/zohd-drift-walksnail.1760295101.txt.gz · Last modified: 12.10.2025 21:51 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
